Venting

    ***Clearance***   58DVA-HC is an aluminum square horizontal termination cap with an inner diameter of 5 inches by 8 inches. This cap is used with Direct Vent Pro pipe. One corner has a small wrinkle in the metal. Non-Returnable. ...

6DTC-FP12 is a peaked roof flashing 8/12 – 12/12 with a diameter of 6 inches. This is used with DuraTech pipe and is an OEM DuraVent venting component. ***This is a special order item.***

946-623/P is a 5 inch x 8 inch AstroCap XL for Horizontal Termination. Genuine OEM part

946-604/P is a horizontal vent guard and is required when the AstroCapXL is installed above grade at 7 feet or lower. Genuine OEM part

946-618 is a 6 foot run of horizontal flex vent termination. This kit includes on extra large AstroCap, 6 feet of Z flex 5 inches x 8 inches coaxial liner, vinyl siding standoff, wall thimble, screw, high temperature sealant, spacer springs and an...

946-616 is a 10 foot run of horizontal flex vent termination. In the kit there is one extra large AstroCap, 10 feet of Z Flex 5 inch x 8 inch coaxial liner, vinyl siding standoff, wall thimble, screw, high temperature sealant, spacer springs and...

946-615 is a horizontal flex vent termination kit with a four foot run. This kit includes an extra large AstroCap, 4 feet of Z flex 5 inch by 8 inch coaxial liner, vinyl siding standoff, wall thimble, screw, high temperature sealant, spacer springs and...

770-994 is a 5 inch by 8 inch rigid astrocap pipe adapter. This adapter is only required when using rigid DuraVent Pro pipe. Starter collar reducer 5x8 to 4x6 5/8 is needed with the adapter. This is an OEM DuraVent venting component.

946-771 is a flex to flex adapter with a diameter of 5 inches by 8 inches. Genuine OEM part

946-770 is a vertical flex additional floor kit. This kit includes a ceiling firestop and a firestop spacer that is used to prevent debris from falling into the firestop. Genuine OEM part

946-769 is a vertical flex extension kit with a diameter of 5 inches by 8 inches. This kit includes 20 feet of flex pipe with 10 spacers, 3 wall straps, flex to flex adaptor, hardware and instruction sheet. Genuine OEM part

946-772 is a 20 foot vertical flex kit with a diameter of 5 inches by 8 inches. This kit includes 20 feet of flex pipe with 10 spacers, 3 wall straps, ceiling firestop, firestop spacer, brackets, flex to rigid adaptor, roof support, 36 inch rigid...

6DT-CAI is a chase air intake with rodent guard. This has a 6 inch diameter and is used with DuraTech pipe. This is also a OEM DuraVent venting component.

6DT-SBRU is support box rails with a 6 inch diameter. This is used with DuraTech pipe and is an OEM DuraVent venting component.

6DT-FS is a 6 inch diameter firestop for use with DuraTech pipe. This is an OEM DuraVent venting component.

6DT-SP is a 6 inch to 10 inch snow splitter for use with DuraTech pipe and is an OEM DuraVent venting component.