Venting

4" x 7" Chimney Adapter to Monessen 4" X 6 5/8" Chimney System venting used on older heating units. 46DVA-08AB (pipe extension) is needed to complete the process. Replaces part # MBSPA Genuine OEM part    

4" x 7" Chimney Adapter to 4" X 6 5/8" Chimney System venting used on old Majestic and Vermont Castings heating units. Call us for additional 7TDV product. Genuine OEM part    

Ultra Black Double Wall Stove Pipe series. 8" diameter Masonry Adapter (12” long) thimble sleeve to connect UB at thimble. Comes with flat trim ring.   Genuine OEM Part

Ultra Black Double Wall Stove Pipe series. 6" diameter Masonry Adapter (12” long) thimble sleeve to connect UB at thimble. Comes with flat trim ring.   Genuine OEM Part

0002768 is a galvanized appliance adapter with an inner diameter of 4 inches by 6-5/8 inches. This is used with double wall Direct Vent Pro pipe.   This is an OEM DuraVent venting component.

Flue Adapter 45 Degrees - 846-508 Genuine OEM part

Flue Adapter 30 Degrees - 846-506 Genuine OEM part

NC6IA is a 6 inch insert boot for use with close installations. This is a 14 inch offset that allows adjustment in the firebox. The top collar accepts OD Flex liner or rigid pipe. 

This Draft Hood Adaptor is a complete assembly and is ready to fit onto your gas stove in a vertical vent application only. With the Draft Hood Adaptor correctly installed and wired to the gas control valve, your Direct Vent fireplace can be vented like...

This Draft Hood Adaptor is a complete assembly and is ready to fit onto your gas stove in a vertical vent application only. With the Drafthood Adaptor correctly installed and wired to the gas control valve. Your Direct Vent Fireplace can be vented like a...

The FSDHAGSLP is a Freestanding Draft Hood Adapter for use on Vermont Castings' direct vent gas stoves.

The CCSLP is a SLP starter adapter for use on Vermont Castings' Radiance, Stardance and Oxford gas units.

946-563 is a coaxial to colinear adapter kit. Genuine OEM part

510-994 is a rigid pipe adapter with a diameter of 4 inches x 6-5/8 inches. The adapter is only required when using rigid pipe. Genuine OEM part

948-367/P is a 4 inches by 6-7/8 inches flex to flex adapter. Genuine OEM part

770-994 is a 5 inch by 8 inch rigid astrocap pipe adapter. This adapter is only required when using rigid DuraVent Pro pipe. Starter collar reducer 5x8 to 4x6 5/8 is needed with the adapter. This is an OEM DuraVent venting component.